Back to solutions

A fitted sheet fitter

  • Virginia Tite
  • Oxfordshire
  • OX19/1453/91/VBT
  • Complete
  • 1 comments

The solution

A shaped fitter was made from Polymorph. It fits into the last corner of the sheet and is pushed down till the job is done. A cord was attached in case it was pushed down too far and needed retrieving.  (Polymorph softens in boiling water, can then be shaped and cut….I used strong cooking scissors…. as required. It hardens as it cools and is very strong).

The benefit

This young woman could make her bed independently to her satisfaction. She said her mother would like one too!

Print this page

One response to “A fitted sheet fitter”

  1. SarahForshaw says:

    What an excellent solution!

Leave a Reply

Your email address will not be published. Required fields are marked *

Motability Registered with the Fundraising Regulator Lottery Community Fund Logo
Website by Agency For Good

Copyright 2024. All Rights Reserved

Skip to content