Bunk Bed Extension - REMAP - Custom made equipment for disabled people
Back to solutions

Bunk Bed Extension

  • Blackford Dave
  • Bristol
  • 0720-06
  • Complete
  • 0 comments

The challenge on this project was to adapt an existing bunk bed to enable the new adjustable bed the client was using to effectively replace the lower bunk. In order to do this the bed had to be extended in length by around 400mm and the top bunk needed to be raised by 300mm.

The solution

The existing bed is made of steel tube and box section (purchased from Metals4U) so the height was increased by putting aluminium tube extensions, turned down from their existing 50mm diameter) between the bottom and top bunks.

To extend the length a new top bed frame was made of welded steel box section and wooden slats. Extra rigidity was achieved by adding a single lower beam (to replace the lower bed frame) and a wooden diagonal cross brace .

Finally a new wooden ladder was added.

The benefit

The client can now move about his bedroom in his wheelchair giving him much more independence.

Print this page

Leave a Reply

Your email address will not be published. Required fields are marked *

Motability Registered with the Fundraising Regulator Lottery Community Fund Logo
Website by Agency For Good

Copyright 2024. All Rights Reserved

Skip to content